Realtek 2832u device driver download
Another user has tested the stick with Ubuntu and OpenELEC distributions with kernel 3.14 and the device works out of the box ok.įor earlier kernel versions follow the instructions below.įor the Zazz ezcap DVB-T FM DAB and Twintech UT30 the following driver works : In Ubuntu 13.10 the 3.11 kernel is available with the dvb-usb-rtl28xxu driver out of the box. Configurable vendor information via external EEPROM.Infra-red port for remote control and wake-up, protocols supported are:.7-bit ADC for RF signals level measurement.Delayed AGC with programmable Take-Over Point (TOP).Embedded adjacent and co-channel interference rejection circuit.Superior performance with pre/post/long echo profiles.Automatic carrier recovery over a wide range offset (☘00KHz).Automatic transmission mode and guard interval detection.Single low-cost crystal for clock generation (☑00ppm).Supports multiple IF frequencies (4.57MHz or 36.167MHz) and spectrum inversion.COFDM compliant with Nordig Unified 1.0.3, D-book 5.0, and ETSI 300-744.Embedded ADC (Analog-to-Digital Converter). The RTL2832U supports IF (Intermediate Frequency, 36.125MHz), low-IF (4.57MHz), or Zero-IF output using a 28.8MHz crystal, FM/DAB/DAB+ Radio Support.
REALTEK 2832U DEVICE DRIVER DOWNLOAD CODE
Modulation parameters, e.g., code rate, and guard interval, are automatically detected. It supports 2K or 8K mode with 6, 7, and 8MHz bandwidth. The RTL2832U complies with NorDig Unified 1.0.3, D-Book 5.0, and EN300 744 (ETSI Specification). The RTL2832U is a high-performance DVB-T COFDM demodulator that supports a USB 2.0 interface. (from the specifications page at RealTek )